- High performance and long-term reliability
- ”Snap-on” assembly on DIN rail (EN50022)
- Configuration and calibration by the front panel
- Calibration executable with the certificates of transducers, or with dead weights
- Serial RS232 output, ASCII & MODBUS protocols
- The dimensions of width contained allow to place a large number of transmitters within the electrical panels automation
- Interfacing with intrinsically safe barriers for use in hazardous areas
Trasducer input voltage: | 4 Vdc (max 4 cells 350 Ohm) |
Measuring range: | –4 ÷ +4 mV/V |
Displayed sensitivity: | 0.02 V/division |
Linearity: | < 0.01% FS |
Gain drift: | < 0.001% FS/°C |
Display: | 5 digit, red LED (7 segments), h 7 mm |
LED status: | 2 red |
D/A convertitor: | 24 bit |
Internal resolution: | 16.000.000 counts |
Visible resolution: | 60.000 division visible on net weight |
Divisions value: | 0.001÷50 adjustable |
Filter: | 0.02÷25 Hz adjustable |
Keyboard: | 3 mechanic buttons (under the red window) |
Tool voltage: | 24 Vcc ±10% – power 2 W |
Temperature range: | -10 / +50°C |
Storage Temperature: | -20 / +60°C |
Serial door: | RS232C half duplex with ASCII protocol |
Baud rate: | 2400÷115200 adjustable |
Fieldbus protocol: | Ethernet IP |
Baud rate: | 9.6 K/sec ÷ 12 Mbit/sec |
Regulatory compliance: | EN61000-6-2, EN61000-6-3 for EMC; EN61010-1 for electrical security |
Electrical connection: | Terminal screw pass 5.08 mm |